Installation Overview

The following steps provide an overview of a typical installation. The information also identifies the recommended installation sequence.

1. Mount the RM4150, RM4150S, RM4151, or RM4151S — determine where to place or mount the RM4150 or RM4151.

2. Connect GPS and GSM Antennas — connect GPS and GSM antennas.

3. Connect Power Supply — connect incoming power in DC Input connector of RM4150 or RM4151.

4. Connect Unit Ground — connect ground wire to rectifier.

5. Power on the RM4150 or RM4151 (refer to Placement or Mounting Requirements for location of switch).

6. Connect configuration cable (refer to Placement or Mounting Requirements for location of USB config port) and then start Bullhorn Tools software.

7. Connect Relay — if using RM4150 or RM4151 to interrupt rectifier current, install and connect a mercury or solid state relay to the unit.

8. Connect Input Wires — connect inputs to RM4150 or RM4151 input channels.

9. Configure RM4150 or RM4151 for service using Bullhorn Tools software (Configuration Overview).

10. If enclosure will be placed (instead of mounted) inside rectifier, place RM4150 or RM4151 to the rear or front, ensuring that the air vent is left as unobstructed as possible.