Installation Overview
If wires are to be buried or covered, conduit must be used to protect wires.
The RM4210/RM4250 and RM4211/RM4251 units can be installed in a similar manner, with only a few minor differences. Refer to the specific unit's installation section for instructions:
The following steps provide an overview of a typical installation, as well as the recommended installation sequence.
-
Determine where to place or mount the unit.
-
Make connections to the test station.
-
Install test station adapter.
-
Make connections to the unit.
-
Test unit communication.
-
Secure the unit.
-
Configure the unit for service using Bullhorn Tools software or Bullhorn Tools Mobile application (refer to RM4210/RM4250 and RM4211/RM4251 Configuration).